12/06/2010 newsletter - CANGOclick The only one contactless CAN reader

Hello,

We know that there has been a big problem that kept occurring each time when connecting the vehicle`s CANbus or J-Bus (J1708/J1587).

Once identifying the CAN_High and CAN _Low we then had to find the way to connect to them. The first way to use the right connector in order to realize this, which in its self poses a big challenge and most of the times even impossible to realize, not to mention it is also very expensive because we had to have a separate connector for each of them, when if possible, for every vehicle/equipment. Or you could connect through the cable, after you find a good place to connect, by striping and soldering to it or crimp in order to have a physical CANbus connection.

Now you can avoid all these inconvenience by using our contactles CANbus reader: CANGOclick

CANGOclick can be used to read CANbus and J-bus (J1708/J1587) and it is available in two versions:

                  -   CANGOclick like cable accesories for our FMS interfaces

                and J1708 interface, or

                   -   CANGOclick cable for your trace&tracking devices.

            -   Find the proper CANbus (CAN     High/CAN Low) or J-Bus (+/-) wires;

            -   Place the CANbus/J-bus wires in right position on to CANGOclick guidence cover;

            -    Close permanently with one click;

             -    Connects to the CANGO FMS interface or at your device if is CANGOclick ready;

        -     Reads through wire isolation.

        -   No direct CANbus and J-bus connection;

        -   One cable fits all vehicles/equipments;

        -   100% accurate recovering of CANbus and J-bus data;

        -   100% non-intrusive technology;

         -   Safe and reliable reading of CANbus and J-bus data;

         -   No soldering, wire cutting or crimping;

         -   No physical wire to wire connections.